JINYINGUHF Passive RFID Long Range Card Readerfactory default support WG26/WG34,RS232/RS485,it available customized WiFi function..Here  listed TCP/IP ( Ethernet ) Configuration for your check:Open “RFIDDemo.exe” in Document of “RFIDDemo”;Connect to…

Quick Write Card Number(WG Number)1, connect the pc and reader use the serial port, and use the “RFIDDemo.exe”; if write fail, then move the tag , and write tag again, until write succeed.

Reader Encrypt Tag1) connect the pc and reader use the serial port, and use the “RFIDDemo.exe”;2) Press”F8” 5 Time3) Choose then “Enabled”, and set password, then set Parameters [Set Para].4) Now, put the tag on the reader, the reader is not beep;Pr…

Deal the same number for WG data1)  connect the pc and reader use the serial port, and use the “RFIDDemo.exe”;2) switch to “BASE SETTINGS”, and set the parameters;3) switch to “READ DEMO”, and swipe same tag;4) select value for the drop-down li…

Questions for UHF RFID Reader:Connect ACB Controller,Non WG outputCard Number can’t upload Answer:Make sure communication is Wiegand. Demo.exeBase Settings >> Default All >> Set Para Check Wiring Diagram: UHF RFID ReaderAC…

Tools>>Interface SettingClick Right mouse, Input “ 778899 “

Management Software for ACB-001, ACB-002, ACB-004 Network Access Controller,How set a limit for persons inside? It means the client want to enter into a room only 10 persons, when reach this number to denied the acces.. Please kindly check as be…

Restore the password by connection 2 (SDA) and 3 ( GND ) of 5-pin white socket on the controller for more than 3 seconds..【Current Password】: 654321More details for  ACB series Network Access Controller, You might check our website:https://www. JINYING.…